ALTIUM CUSTOM FOOTPRINT FROM REGION , problem

[keen]

hi all, pls an advice, custom footrprint .

- footprint from region with pads was created .. its ok
- routing: than, when I manualy route PCB nets, track properly avod footprint region if it is not connected on this region .. its ok
when Situs rout nets, tracks go over the footprint region, WHY ???? something somewhere I did not set ?? WHO knows ?
BC I am a littlebit tired from Pdf's ..

regards .. me

 

[kabaleevisu]

Hi keen,
please post the datasheet and i will try my level best

 

[keen]

Kapil,

what do you mean with 'datasheet' ? maybe you mean a picture ?

me ..