Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
You can calculate leakage power by report_power command. But dynamic power calculation will unaccurately.
Dynamic power depends on work mode you use. For example if you are modeling some arithmetical operations result can be differ from that calculated in logical operation.
For more accurately measurement of dynamic power you should make following steps:
1. Get SDF file (for backend netlist it includes RSPF information)
2. simulate your netlist with SDF and to generate VCD file. Clock frequencies should be the same as in DC.
3. convert VCD to SAIF
4. read SAIF file and report_power
Usually, calculated value differs from calculated without VCD and simulation. And it have good correlation with chip.