Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
T3 and T5 violations are observed in fastscan. it means that there is some issue in the fastscan shift procedute. To resolve it
set the gate reporting to trace, and use the Report Gate command for the
gate ID number displayed in the error message. This can help you to identify where the
blockage occurs; tracing back from the inputs helps you identify how to correct the problem.
T5 is also similar, it means that sets/resets are not inactive and they have either x or active value on them. again issue in the shift procedure.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
