Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks .what is the o/p wave form?Can this power lcd tv.Cos I design using sg3524 it cannot power lcd tv(samsung) but it power other load in my room both lg tv flatron
Waveform is something like this: http://www.oynot.com/images/modified-sine-wave.jpg
If it didn't powered the LCD TV, then there could be some possible reasons- output power is not sufficient for the tv, the tv circuit may be rejecting modified sine wave, or anything else.
I done thank that power is problem.I can more of the tv.In the design I use 10 pcs. of IRF150N .Push pull mode.I use sg3524.Waveform may the problem because when i connect .01uf at the inverter output the tv will try on and off .Thanks
If o/p of oscilator(sg3524/3525) is connected to negative feedback of Opamp(lm324)and 0.1uf(104) is connected to o/p and to negative.Can this alter the waveform of inverter?Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.