Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Here, classical filter design method i know but i am not sure about filter design for following situation.
picture is given below for detail where 50 ohm is matched to capacitor and resistance load of 20 ohm, for band of 6 GHZ with center frequency of 5.5 GHz.
i want to use cascode topology in which i have to short two oppposite pins of ic on substrate, where i used mlin and mcurve below the ic to connect these 2 pins i.e. gate and drain but it harms s-parameter and noise. So i need help, Reply if anyone have good knowledge about layout design so i...
it was helpful but can you tell me, with this result can i design amplifier and if yes then how should i bias to achieve 4V 40 mA Q-point.. what should be my next step
i have done small signal analysis for 2 stage amplifier using ATF34143 for 4V,40 mA for Vgs=-0.41 but i am new in this so i need help for gate bias and drain bias
i did already but i get harmonic distortion and low power added efficiency.
i want to know what should be Vgg if Vgs is found -0.41...
what is uw/mom simulation ? can u explain little?
i m using s2p file for transistor only, do u know how to add capacitor and inductor s2p file in software ADS 2009
hey, i am using ATF34143 for 2 stage broadband lna and i got good result with gain, noise figure and return loss i.e. s11 and s22.
But i have designed with ideal component inductor and capacitor, i want to replace it with vendor's component. As i am using ADS 2009 software for it, they provide...
i have ATF-34143 .s2p file, .zap file, and footprint (pdf ) also, collected from avago site.. i designed 2 stage amplifier using 2 port s2p block and going to design layout for it.. but i m confused with it bcoz its having 4 pin ic where two sources are given.
if i assign component artwork as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
