Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I tried using the import wizard and got the same result. I think this needs to be converted in Allergo into another format that Altium can read and that can be imported into Altium.
For anyone who wants to know, the solution is that the mini PCI-e slot can read USB2.0 but is unable to read USB1.1, and my device can only send data in USB1.1 format. So now I have to figure out how, in my code, to make it transmit in USB2.0, because I know my chip should be able to.
OK, so i figured out that a USB flashdrive works just fine using the +5V, D+, D-, and gnd
Do you think my other USB stuff (like my desktop's keyboard) doesn't work on it because of driver issues?
also the device is:
Rugged PC Review.com - Rugged Tablet PCs: Handheld Algiz 7
and right now I have my device wired into the webcam's port, but I want to move to one of the mini PCI express ports
Basically I think what i'm asking is if pin #1, "WAKE#" needs to be set in order to activate the PCI slot?
and if any other pins need to be set or used to enable the USB data+ and -
also, thanks I didnt notice that the 5V on my PCI test card wasn't connected to anything >.< so I'll need a 3.3v...
Naw man, I have the PCI driver installed, but when I plug in my PCI card and put a voltmeter to it, I dont see any power
I have this guy:
**broken link removed**
hooked to my USB device, but Im not getting it to register as there.
any tips?
Hi, I have a USB device and I would like to plug it into a mini-PCI Express slot. I found a USB to PCI interface and I am going to buy it, but I was wondering if I need to do anything additional when connecting it? Has anyone done this before?
So I used altium's footprint wizard to make the footprint given here: **broken link removed**
This is my first time making a footprint and I was wondering if the number of vias matters?
the part is: https://media.digikey.com/pdf/Data%20Sheets/SMSC/LAN8720.pdf
my footprint is attached
also...
These are increasingly becoming popular at my company and one of our guys has been tasked with trying to blow one up, or at least start a small fire using any method he can think of short of straping thermite to it. Thus far he has only caused heat increases but no fire, and I was curious if...
*UPDATE*
someone had a 134kHz rfid tag and reader, and I found that I am able to read thru the hole in titanium.
it should be noted tho that it doesnt work if the tag is held against the titanium, only when it is held about 1/4th of an inch away. the reader can be held right up against the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
