Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Vibration frequency in sinusoidal. But it move in vertical axis as table move 1-2 mm up side so no inclination.In such case how tilt sensor gives output
Dear Sir,
I use ADIS16209 MEMS sensor for sensing tilt angle. I face following problem, can u suggest solution to avoid this problem.
In steady state condition sensor gives output as per change in inclination angle. When sensor with its mounting plate kept on vibration test having operating...
Dear Member,
I Require Exhaust Fan with following specification.
1. Speed control using external regulator or control
2. Operate on 230 VAC, 50 Hz
3. Size 9" or 12 "
4. application : Industrial Curing System
If u know any supplier or any solution please share
Actually my placement is matrix but Tx & Rx section away from each other around 2 mtr. So I have no idea when tx active say TX3 active than i require to check is RX3 is active or not like this
I want to design circuitry in which we use 12 IR Rx-TX pair which make matrix. Now when any beam cut than alarm on. Can u suggest which protocol use for Tx & also at Rx such that i know exact location of sensor. Is RC5 is okay or something other
ADC resolution affect ur accuracy. If u require good accuracy than use more bit but at same time ur require good controller having high speed ADC with simultaneous sampling, good floating point data support.
Plan ur specification than make paper work to select controller
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
