Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi there
a liitle prob in c
i have 2 input port A0 and port A1 i want to put on 1 led if both of them pressed (closed) together...i found out a solution but if 1 input is close
led not working ...but if my two input is close led goes on ...and when my two input is open led goes on too...
Hi i want to use rs485 with microc pro but not with the 485 microc library... like uart with an sn65176 transceiver, cause my project dont need address and other data from 485 microc library
i have to send to unit preamble (FF FF FF FF FF) some data and at end checksum value at 1200 baud 8 bit...
Hi there i found this little example on how to use power management on 16F...i want to use it on 18F2580
with Micro C i cant compile on 18F i think it's option_reg the prob
Can somebody translate the code for use the wdt in 18F?? i want to knows wdt on 18F for future code
Thanks for help...
Hi there i'm building an canbus with 3 node..2 collector node 1-temperature 2-adc voltage.
data send on display node with 2X16 display line 1 is temp line 2 is volt
Everything works fine....
my little prob is if one of the these node is down (or missing) my display node
stop of working (cause...
ok...the uCs is 18f2580 ...osc 20 mhz.....i'm on the road now but i can send you tonight the complete file with the microc project files
Thanks again
Regards
Hi i'm newbie ....i found an code for can bus in mikroc work fine with mikroc 7.0.0.3... but i want to finish my project in microc pro
Does somebody help me to convert my .c file in .c pro???
i think my prob is about syntax an variable declaration...
Thanks...
Hi i'm studying rs485 i took example from microc ...i built an long range adc voltmeter and a ds18s20 long range thermometer working fine...the only little prob i cant send more than 3 bits of data...i use 2 easypic board easypic5 and easypic7 i built and use 2 max485 external board ...working...
Hi there i try to build an error code monitor with 1 led..i need like 10 input when input 1 is selected led is blinking 1 time after 3 seconds off blinking again...
when input #2 is selected led is blinking 2 times 3 seconds off and blinking again....number #3... 3 times...until like that to #10...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
