Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I can be wrong, but I think it may be that your counter counts bytes. making it easy to work with char bytes etc. . more program codes may or organized into words. which forced him to rise to 4 bytes ie one word at a time
You should see what the geometry of the organization of memory and it is...
just change the door 25 to 587 (yahoo) and returned to work perfectly. gate 25 is no longer in use for almost any service provider's SMTP
OK
AT+SAPBR=4,1
+SAPBR:
CONTYPE: GPRS
APN: claro.com.br
PHONENUM:
USER: claro
PWD: claro
RATE: 2
OK
AT+SAPBR=3,1,"CONTYPE","GPRS"
OK...
As long as I know people SimCom. still would not be soon on SSL support. regarding the use of the gate 25, in my case works perfect.
Let me tell you that this version just does the following firmware resolves the encryption (base64) for your loguin. ie could do it manually using commands via...
Drajat
The example above works perfectly. but there are some details, gmail does not work with this firmware that does not have SSL encryption, then you will have problems in gmail, yahoo works well in gate 25 which is a simple SMTP door, I think you should check out these details.
benhaham
* I did several upgrades and as experience I can tell you the best way or at least that I do not give less errors is the option 460800 baud with the flash loader V1.01
I think you should be able to do normally, just remember that the data addr in the case of program memory in the standard model 8051 is 0x0000, ok?. And the models that you raise is the same, but you must inform the MCU that these to use the bank and not the external flash,
do not remember now...
Re: adc code shows error
if you measure through an opto, what you see is the current variation THROUGH the LED , according to the variation of voltage (Ohm's law)
you should be able.
Just need to add in the file MCU DEFINITION , specific register addresses, for your new chip.
The other common register addresses must not alter, that all the 8051 MCU architecture are the same
Re: adc code shows error
looking at your code there are some oddities that do not understand.
for example in the code main () {} put in a loop while (), init adac, this does not make much sense, once you tell the ADC that resolves their just right through the interruption is not necessary that...
Re: adc code shows error
this is applied in a ATmega2560, and this for unit conversions in this case the upper channels are enabled, if you please do it as self CONVERTION or via IRQ, you can manipulate it within the scope of the IRQ
TEM4 = Select_chanel (13);
extern int CHANEL_ADC;
void...
man, the friend above AmrZohny proposal is fabulous, beyond that, you'll see on your development focus, today has many 32-bit cores, each with a deversidad of proposals in relation to the cost benefit. ARM11 ARM7 ARM9 Cortex1 AVR 8 etc etc ... then you should also see the tools necessary for the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
