Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Virtex 5 pins and voltage level

Status
Not open for further replies.
S

SUNBELT

Member level 2
Joined
Oct 4, 2005
Messages
42
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,652
I am trying to use virtex 5 (ml501), It has a lot of input and output pins. I am using "planAhead" option to assign the pins, (in ISE). My problem is that on the board I can not find the corresponding pins, for example which pin is W13. I think it should have a data sheet explaining it, but I could not find it.
I also need to input some data, so I need to know what is the input voltage level, (e.g. 3v for 1).

Where can I get this information?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top