Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Query in expedition schematic tool (design capture):

Status
Not open for further replies.

Siva_vijiy

Newbie level 5
Newbie level 5
Joined
Dec 10, 2008
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,343
design capture bus naming

How to use the bus connection.
When I run the package for the design which had buses to interconnecting the set of nets. It show the error like “Wire ripped from bus is not a valid bus member” for each net.

Please help me to resolve this problem.
 

esrope designer

hi,
try any one of these option
1. In central library connector symbols check whether ESROPE symbol is there
2.give same bus name

i think first option will help to correct your problem
 

expedition +schematic

Thanks for the reply... I will try it and let you know the things.

Added after 48 minutes:

Do you have any .sbk file(schematic file) used with the buses? If so, please upload me. I need it for reference.
 

expedition bus design

Hi shabharudin,

Finally I resolved the problem. Thanks for the support...
 

Re: expedition bus design

Hi Siva,


I am also getting the same Problem , what is the procedure to fix this one...


Regards

Karthik
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top