iqFizz
Newbie level 2
Hi all,
I am currently planning a transmission line for a received 2.4GHz signal. Unfortunately, I’m not very experienced with RF design. At college, I was attending a course of high frequency. But this doesn’t help me with my problem. I don’t know how I connect the transmission line to the matching network and the IC-Pin (mixer). The coplanar waveguide with lower ground plane (CPWG) is 1.60 mm (63 mil) wide. All smd pads are much smaller. Figures below show first ideas of the layout. How would you connect the components?
Thanks
iqFizz
I am currently planning a transmission line for a received 2.4GHz signal. Unfortunately, I’m not very experienced with RF design. At college, I was attending a course of high frequency. But this doesn’t help me with my problem. I don’t know how I connect the transmission line to the matching network and the IC-Pin (mixer). The coplanar waveguide with lower ground plane (CPWG) is 1.60 mm (63 mil) wide. All smd pads are much smaller. Figures below show first ideas of the layout. How would you connect the components?
Thanks
iqFizz