petarpav
Full Member level 5
pic12f675 debug
When i use ICD-S to debug PIC12F675 on CCS, ICD-S upload program and then says:
"Could not start target: The target was not halted after reset Check the target oscillator and MCLR."
I use internal oscillator on PIC12F675, and MCLR pin is connected to VCC via 10kOhm resistor.
Anybody can help me?
Thanks.
When i use ICD-S to debug PIC12F675 on CCS, ICD-S upload program and then says:
"Could not start target: The target was not halted after reset Check the target oscillator and MCLR."
I use internal oscillator on PIC12F675, and MCLR pin is connected to VCC via 10kOhm resistor.
Anybody can help me?
Thanks.