Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Chuckey, i had moved the fridge from one point to another, just few yards apart. I think, the coil inside the compressor got shorted. However, a technician visited and had got it replaced when i was not there. I think, it was the fault of compressor.
I didn't know that, which oil are you...
When i check the input leads of the voltage regulator, i find it to be shorted.
I called a technician and he said that the compressor is faulty, and it needs to be replaced(for free) as i have a warranty on the product.
The voltage regulator has a knob in it. While shifting the refrigerator...
Any diagram/link for this.
Why exactly should the 3 phase be balanced. I know, it is to control neutral current. What happens if unbalanced? I also heard that i will be charged more if i draw current from an unbalanced system. Is it true?
Thanks chuckey, i was able to understand a few things. Any simulations for this?
Case 1) Block A uses 500A, Block B uses 500A & Block C uses 500A - So balanced.
Case 1) Block A uses 500A, Block B uses 50A & Block C uses 10A - So Unbalanced. What will be the neutral current?
Practically, i've seen that it is not possible to distribute the load equally. How does the current on neutral happen? Neutral is to be grounded, it will be on zero voltage as long as it is grounded. Do they use DC supply for broadcasting? I'm confused, if they do so then how would 50HZ ripple...
Why does 3 phase needs to be balanced? What is the requirement?
Also, i heard that unbalanced 3 phase is expensive. Why/How so?
How do they balance 3 phase in distribution lines?
Hi, i wanted a Eagle library files for various components. The components are listed below.
Please tell me where i can get them or provide me the link or attach the file.
1) Receptacle / Bulb Holder
2) 1:1 Transformer
3) What should i use to denote mains voltage? (or what is pointed box-type...
thanks kripacharya, chuckey and Brad
How will the tank pressure effect? the pipe is not over head tank has no immersed water pipe. Please give me a link to read about this.
I'll check for the hotness of the pump; sound and exact time it takes to complete one cycle of filling the tank. I'll...
Thanks, that helped in solving the problem. But, how can i simulate a rig up circuit? Should i use any other tool for this? I think the NETs need to be added at nodes with 3 or more wires meeting. Right?
I wanted to sketch a circuit diagram, the ic used was icl 7107 for which i didn't get the library file/component on eagle. So, i continued drawing the schematic using a 40 pin DIP package. The problem is the component seems to be too small. I've posted the image, i was unable to clearly draw the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
