Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Windows Starting Problem

Status
Not open for further replies.

ruhulamineee

Newbie level 6
Joined
Jul 28, 2012
Messages
11
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,357
Hi,
I have installed windows 7 in my desktop pc.
The configuration of my pc is:
1. Dual Core 2.00GHZ
2. RAM 1GB
3. Board Intel DG33FB
4. Hard Drive 250GB(free space in C: drive is more than 8GB)

Display is not shown after welcoming it.
Sometimes it is being started but it is taking more than 8 minuses to comeback in normal condition of desktop.

What should I do for it.
 

Hi there,

your config is to poor to support the operational system. You need at least 2GB of Ram to run without major problems, the space on HD is a problem too. Why keep less than 20GB for Windows 7? Certainly you'll need more.
 

Try to use some ram booster software also free up space in C Drive.
 

Hi,
I have installed windows 7 in my desktop pc.
The configuration of my pc is:
1. Dual Core 2.00GHZ
2. RAM 1GB
3. Board Intel DG33FB
4. Hard Drive 250GB(free space in C: drive is more than 8GB)

Display is not shown after welcoming it.
Sometimes it is being started but it is taking more than 8 minuses to comeback in normal condition of desktop.

What should I do for it.

Add more RAM to system.

Check hardware status, maybe something is defective.

Check dust on CPU heatsink. Clean if dust exist.
 

Harddisk check for bad sectors.. And after loading windows check system logs for any error related to hdd.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top