Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Wiggler JTAG for TI C2000 with LPT port

Status
Not open for further replies.
L

letan

Member level 3
Joined
May 21, 2007
Messages
64
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
VietNam
Activity points
1,713
Hi everybody,

I have a board of Wiggler JTAG (LPT), I want to programmable TI C2000 but I can't connect my device. What must I do? Pls help me.

Thanks.
 

Hi,
The first thing you have to do is to check whether or
not your wiggler works well.
Check the circuit and pcb carefully.Maybe the problem just results from a wrong used risistor.
Then pull the inputs of 74HC244 to Vcc and Gnd and measure the outputs with a voltmeter to see whether they gives the correct response.
Then,if the problem still exists,see the settings of the software(LPT address,target setting,etc.).
Good luck!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top