Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Why simulation toward ms and seconds takes a very long time?

Status
Not open for further replies.

leongch

Member level 2
Joined
Dec 22, 2005
Messages
44
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,692
hi,
I was trying to simulate a step down frequency from 25Mhz to 1hz using the altera QuartusII software. After i complete my code, i found it takes more than 3 hours at least to simulate over 3 seconds... Actually wat determine the simulation time require? The complication of the design or the range of the simulation time? How do i going to shorten the simulation time required in the range of seconds?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top