diablo39
Newbie level 4
i have recently decided to do some programming with microcontroller.
I have looked through internet and found some material on RX62N development board seems like nice board with alot gadgets on and found some good course material. Has anyone else used this board, were the any problems, was it easy to use, and good board to learn basic programming and maybe advance further.
I have also looked at 8051 but not extensively, but have looked at pic and like this as it comes with microlab software which seesm like you can test programs on software provided allowing to learn with out having pic which seems to be good to start point, also like the idea can buy developement boards for this device.
Then have also looked at AVR which seems ok but cant find much material on programming in form tutorials, well as someone who has some knowledge of microntrollers, but only really run simple programs on micro at college were everything was set up (i.e hadware was designed, system was set, all had to do was write program and download run from set instructions).
Well were to start, am very intrested in buying RX62N but unsure for someone learning is that good starting point.
so any advice please, which micro to start with, which dev board, which is best to learn for indrustry reqiruments, should i start with assembly or c or both.
I have looked through internet and found some material on RX62N development board seems like nice board with alot gadgets on and found some good course material. Has anyone else used this board, were the any problems, was it easy to use, and good board to learn basic programming and maybe advance further.
I have also looked at 8051 but not extensively, but have looked at pic and like this as it comes with microlab software which seesm like you can test programs on software provided allowing to learn with out having pic which seems to be good to start point, also like the idea can buy developement boards for this device.
Then have also looked at AVR which seems ok but cant find much material on programming in form tutorials, well as someone who has some knowledge of microntrollers, but only really run simple programs on micro at college were everything was set up (i.e hadware was designed, system was set, all had to do was write program and download run from set instructions).
Well were to start, am very intrested in buying RX62N but unsure for someone learning is that good starting point.
so any advice please, which micro to start with, which dev board, which is best to learn for indrustry reqiruments, should i start with assembly or c or both.