Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What kind of sensor is this ? and how can I use ?

Status
Not open for further replies.
If your Arduino interrupt is level sensitive rather than edge sensitive, the best solution is to invert the output of the comparator. You can use the other half of the LM393 to do that or add a transistor at the output ot invert it or even rewire the existing circuit to work 'upside down'.

Brian.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top