Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What are theese resistors for?

Status
Not open for further replies.

Sudhir.K.A

Member level 2
Joined
Feb 26, 2006
Messages
46
Helped
6
Reputation
12
Reaction score
1
Trophy points
1,288
Location
Bangalore
Activity points
1,798
Hi Beffo,
The voltage drop across 1 ohm is fed to the input of the comparator. So 1 ohm is used for generation of comparison voltage generation.
The voltage drop across 0.1 ohm is given to the input of voltage follower whose output will be the Vm-drop across 0.1 ohm. So this drop across 100 ohms. Which will result in I proportional to voltage drop across 0.1 ohm. Which is fed to 1K ohm resistor. This will result in amplification of the voltage.So finally 0.1 ohm voltage drop is amplified 10 times and output with respect to ground is obtained.

Regards,
SUDHIR
 

Beffo

Junior Member level 2
Joined
Feb 21, 2006
Messages
22
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,493
so what is the purpose of the circuit connected between 0.1 ohm resistor and AND-Gate?


Is it simply that the controller only controlls motor while there are Vm present at correct voltage?

While my motor drives of 24 V and 5 A there will be an effect of 2.5 W over just the resistor.... Correct?
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top