david90
Advanced Member level 1
What are some rules/strategies that I should follow so that I can minimize the number of wire jumpers on my PCB?
I often find myself routing a signal that it blocks out other signals or find myself in a situation where I can't route a power/gnd trace to an IC because a trace closed it off.
Does PCB route planning start at the schematic stage?
I'm a total newbie btw.
I often find myself routing a signal that it blocks out other signals or find myself in a situation where I can't route a power/gnd trace to an IC because a trace closed it off.
Does PCB route planning start at the schematic stage?
I'm a total newbie btw.