Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Can someone help me in the values of capacitors that should be place in this circuit in order to operate it properly as a voltage amplifier (small signal)
C4 and C6 have to be dimensioned related to an impedance, that's the sum of an output and an input impedance, not "both" impedances (however this may be achieved?). In the present case, the input impedance of next stage (in case of C4) as the higher value of both could be use for calculation.
C2 and C3 should be dimensioned in relation to 1/gm (≈ 26 mV/Ic) rather than R4 and R10. 1/gm beeing tenfold lower than the said resistors.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.