020170
Full Member level 4
hsim vcd
In using HSIM ( or NanoSIM), HSIMVCD2VEC command converts VCD file to Stimulus Input signal easily. Analog & Digital Block were easily simulated by this way.
question : I written SIG (signal information file) like this
#format %[#]
#scope tc_top
#in RESETB
and I extracted VCD file from verilog.
But I get an error log file like this.
Compiling "RGB_to_SD.sig" (signal info)
Compiling "RGB_to_SD.vcd" (VCD)
ERROR:No signals found in vcd file. This could be because of an error in the VCD file or, the scope was not specified using the signal info file
Error: cannot open file "hsim_vcd2vec.vec"
How to solve this problem?
thanks
In using HSIM ( or NanoSIM), HSIMVCD2VEC command converts VCD file to Stimulus Input signal easily. Analog & Digital Block were easily simulated by this way.
question : I written SIG (signal information file) like this
#format %[#]
#scope tc_top
#in RESETB
and I extracted VCD file from verilog.
But I get an error log file like this.
Compiling "RGB_to_SD.sig" (signal info)
Compiling "RGB_to_SD.vcd" (VCD)
ERROR:No signals found in vcd file. This could be because of an error in the VCD file or, the scope was not specified using the signal info file
Error: cannot open file "hsim_vcd2vec.vec"
How to solve this problem?
thanks