Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The command "board" will switch from the schematic to the board and therefore could have a key set up to do it. I cannot find an equivalent command to switch back. It may be possible with a ULP.
Another possible solution - ALT+0 or ALT+1 or ALT+2 or ALT+3 etc allows you to select windows - control panel, library, board & schematic. The only snag is that the exact number to press with ALT depends on how you opened your files so ALT+1 may be the schematic or it may be the board or even a library.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.