Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

the output of Lm358 is 3.6V instead of 5V

Status
Not open for further replies.

qamar.nust

Newbie level 2
Joined
Dec 30, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Multan
Activity points
1,295
the output of Lm358

Hi everybody,
I am designing a light sensor in which i am using an op-amp(Lm-358). What I have studied about LM-358 is that when there is more voltage at non-inverting end than at the inverting end then at the output we get the maximum voltage. But in my case what i get is 3.6V instead of 5V.What should I do??
any suggestions????
 

penrico

Full Member level 5
Joined
Aug 28, 2001
Messages
286
Helped
27
Reputation
54
Reaction score
8
Trophy points
1,298
Location
Argentina
Activity points
2,393
Re: the output of Lm358

You can put a transistor in the output of LM358 with a pullup to 5V, then you can get 0-5v levels.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top