qamar.nust
Newbie level 2
the output of Lm358
Hi everybody,
I am designing a light sensor in which i am using an op-amp(Lm-358). What I have studied about LM-358 is that when there is more voltage at non-inverting end than at the inverting end then at the output we get the maximum voltage. But in my case what i get is 3.6V instead of 5V.What should I do??
any suggestions????
Hi everybody,
I am designing a light sensor in which i am using an op-amp(Lm-358). What I have studied about LM-358 is that when there is more voltage at non-inverting end than at the inverting end then at the output we get the maximum voltage. But in my case what i get is 3.6V instead of 5V.What should I do??
any suggestions????