Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

The geometry of CPW with stubs

Status
Not open for further replies.

cvenkat

Full Member level 1
Joined
Jun 8, 2005
Messages
96
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,288
Activity points
2,065
Stub matching HFSS

hiall,
Can any1 give the geometry of CPW with stubs (short and open) . is it just an extension of signal line on sides ? How much gap shud be left between the gnd and the signal trace in case of OPEN....kindly clarify...
thanx in advance
 

antboy

Junior Member level 3
Joined
Nov 13, 2005
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,445
Re: Stub matching HFSS

I think you can use Micrwave office or Ansoft Designer to design CPW circuit firstly, after you get the phisical parameters, you can use HFSS or CST to verify them.
In this way ,your design process will be much fast!
 

cvenkat

Full Member level 1
Joined
Jun 8, 2005
Messages
96
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,288
Activity points
2,065
Re: Stub matching HFSS

ok thanks
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top