Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Steps to start programming a fresh micro controller

Status
Not open for further replies.
E

emmagood

Member level 4
Member level 4
Joined
Feb 13, 2010
Messages
74
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,288
Visit site
Activity points
1,849
Hello,

I wanted to know the steps to program a fresh micro controller. I could google a few steps viz. burning of fuses, downloading a bootloader etc. Can anyone pls. note down the steps required to program a fresh micro controller. I am using Atmega16 with AVR dude as the programming interface.

Thanks,
Emma Good
 

It is very straight forward .... u just connect ur contoller .... upload ur code at the software ....and it will burn the hex file to ur controller
I recommend using an Arduino board as it will meke ur life much easier :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top