Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Spectre can't start from checkpoint

Status
Not open for further replies.
Fom

Fom

Advanced Member level 2
Advanced Member level 2
Joined
Mar 10, 2004
Messages
630
Helped
84
Reputation
168
Reaction score
34
Trophy points
1,308
Location
Taiwan
Activity points
4,463
I have a problem I can't solve.
Sometimes when I run long-time simulation by Spectre I need to restat the simulation from checkpoint. I did it before with SpectreS without any problem. But after I'm switched to Spectre I can't restart simulation from checkpoint. Spectre always give an error message about convergence. I don't change anything in schematic or simulation setup. I only try to restart from checkpoint.
Anybody have a solution?
Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top