Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] pPar() use and "copy from cellview" use

Status
Not open for further replies.
L

loganhhhh

Newbie
Joined
Jan 2, 2024
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
36
I create a capacitor with Q as a Pcell. This is the schematic.

r/chipdesign - pPar() use and copy from cellview use
capQ schematic

I set the capacitance as pPar("cap") F and resistance as 2*3.14* pPar("frequency")* pPar("cap")/pPar("Q") Ohms. My 1st question: is the way i create pcell right?
If that's right, I use this cell like this:



r/chipdesign - pPar() use and copy from cellview use
capQ use

I set the capacitance as DCBlock_60G. BUT when I click the "copy from cellview" in ADE, nothing happens. The parameter is not in the ADE window. I have to add this parameter by myself. So my seccond question: Does anybody know how to slove this problem?



r/chipdesign - pPar() use and copy from cellview use
ADE window
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top