Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Open the hypfile in in notepad or texteditor go to the line where u r getting error(in this case 32806).In the line put " " for the device name.
for example if line is (? REF=U5 NAME=NC7SZ125M5(X) L=1)
put "NC7SZ125M5(X)" it will work.
How about other errors ?
HyperLynx produces many errors while loading a .hyp file.
Like this :
---------------------------
Error
---------------------------
Illegal pad specified in line 367
---------------------------
OK
---------------------------
Which is this line :
(MDEF, , 0.1496, 0.1496, 180.000, M)
in this record :
{PADSTACK=51, 0.0394
(MDEF, , 0.1496, 0.1496, 180.000, M)
(ADEF, , 0.1614, 0.1614, 180.000, A)
}
I dont know what is this and what does any of these words ("PADSTACK" or" MDEF" or "ADEF") suppose to mean. But it seems it's a record and it will be use in follower lines when defining "NETs"
If it's help I'll attach the .hyp file.
I'll tell you other errors when this one is fixed !
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.