Simulate DC/DC power noise damped sinewave in Orcad 9.2

Status
Not open for further replies.

moro

Member level 3
Joined
Jul 12, 2009
Messages
65
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
2,013
Hello,

i am trying to create a damped sine wave like the noise generated from a pwm power stage.

The waveform must look similar to this


Is this posible in Orcad simulation ?
 

Your waveform resembles 'ringing' like the kind created by resonant action in a loop formed by an inductor and capacitor. Install a resistor in series so that the ringing decays after a few cycles.
A ringing circuit needs a 'kick' to start oscillations. You can start with a charge on the capacitor, or deliver a pulse through a switch, etc.
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…