Aimerbhat
Newbie level 5
i synthesized my code (verilog) containing mainly additions and subtractions and am doing post synthesis simulation in modelsim
in modelsim wave i see,
instead to obtaining differences of two registers , i am now obtaining difference divide by 2
I am not able to figure out the problem.
i even tried re declaring wire resulted by subtraction as wire signed ...but still no change
what is the proper way to give signed operation instructions in verilog..
kindly help
regards
aimer
in modelsim wave i see,
instead to obtaining differences of two registers , i am now obtaining difference divide by 2
I am not able to figure out the problem.
i even tried re declaring wire resulted by subtraction as wire signed ...but still no change
what is the proper way to give signed operation instructions in verilog..
kindly help
regards
aimer