Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

set_dont_touch command in DC, need help asap

Status
Not open for further replies.
A

ajhunt18

Member level 1
Joined
Jul 4, 2011
Messages
38
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
1,554
How to use this command? I tried using this command but nothing happens. It was not supposed to optimize my design, but still DC optimized it. What should be the correct method or steps in using this command in DC? Was it after I compile the design? or Before compiling the design? or before reading the file?

Any help will be much appreciated. Thank You!
 

After elaboration, before compile.

Type: man set_dont_touch in dc-shell.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top