Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

sense amplifier requirement in read operation of sram

Status
Not open for further replies.

rajrevanth61

Member level 3
Member level 3
Joined
Mar 6, 2014
Messages
65
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Visit site
Activity points
429
Hello everyone,

Is there a necessity of using a sense amplifier while reading from SRAM?
 

If you are talking about traditional SRAM, you don't need it since it is all electrical based.
But this century has seen quite a few technology that can "mimic" the standard SRAM/DRAM interface but the essential "store" mechanism involve something other than electronics. For those parts, yes, you need a sensor most of the time for read.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top