Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Because , by tradition things always start of with nothing until you increase them, when plotting the gain curves of devices the inputs always start at zero, so it would seem logical to use this for a schmidtt trigger. So set your input to 0V and start plotting. If you are using PNP devices with a negative Vcc rail the input should then go negative.
Frank
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
