Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Running corners in Eldo

Status
Not open for further replies.
P

philcorb

Junior Member level 3
Joined
Jun 30, 2011
Messages
25
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,283
Location
Trondheim, Norway
Activity points
1,451
I currently run process corners using custom made batch scripts for Eldo. The scripts add the library paths and parameter setup to the start of a .cir file. I then run the all the .cir file varients and extract/sort the results. I have looked at using the .alter command but it seems to not always compute a new operating point for each run. This can lead to convergence problems.

Does anyone run corners using Eldo in a different way? Do you have any suggestions for different approaches?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top