whlinfei
Member level 2
Hi All,
I am drawing the layout using a cmos process.
I am a bit concerned on "contact redundancy ".
It is better to put as many contacts as possible. But is there any minimum number of contacts to place for a connection? what is the rule to follow there ?
say I have a gate connection ? how many via I should put there to connect poly gate to metal one ?
Thanks in advance.
Best Regards,
whlinfei
I am drawing the layout using a cmos process.
I am a bit concerned on "contact redundancy ".
It is better to put as many contacts as possible. But is there any minimum number of contacts to place for a connection? what is the rule to follow there ?
say I have a gate connection ? how many via I should put there to connect poly gate to metal one ?
Thanks in advance.
Best Regards,
whlinfei