Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

RTC chip DS1307 is getting hang

Status
Not open for further replies.

ismu

Full Member level 2
Full Member level 2
Joined
May 12, 2009
Messages
145
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Location
nil
Visit site
Activity points
2,340
am using DS1307 RTC chip , after 1 or 2 days time is not changing , it is on same state , eg :5:59 pm, it is not incrementing , still same time even after 5hrs , and at this time Xtel pin is always DC voltage there is no sine wae at Xtel pin , i think Osscilator is in off state , when we are trying to write 0x00 in 0th location , it will start counting agian ,


my software logic is am reading I2C data two times in each second .

in some clock ther is no problem ,
 

Refer my blog for more information. I think u just run simple code in which data & display it. If it work fine then add additional code if any
 
  • Like
Reactions: ismu

    ismu

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top