Hi,
It really isn't that hard.
First: complete the schematic. Now for the third time:
There are some issues:
* IC2, pin1 is not connected to supply...
--> instead of connecting pin1 ...now it seems you disconnected pin10.
Do you want your circuit to work? Then connect them.
********
Constraint:
Till now I thought you want a two layer design....now it seems you want a single layer design.
--> I strongly recommend to use two layers. One side GND (mostely), the other side signal routing.
*****
Placement. Critical signals / parts first.Try to remove signal crossings.
...
Then routing. Critical signals first.
Different trace widths.
******
You may add your project as an zipped attachment.
****after your update****
Now pin1 is connected, but not pin10.
Why the diversions? Keep the signals short.
Klaus