Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all,
I have a sample of an LED Driver and needs to open it without breaking any part.
attached is the covering picture of the product . It seemed that the cover is a heat sink itself.
I just need a way to open it safely
Thank you,
Potting material can be removed. The hardness of the potting material will decrease if you put it in an oven with 120 deg C. Be careful the wire may burn out.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.