elektr0
Full Member level 5
Hello,
could somebody please help me with the EAGLE PCB tool.
1) Is there a possiblity to merge (boolean add) RECTS, SIGNALS, WIRES within the board tool
2) Eagle does not recognize, that signal parts are connected through other layers by vias ?
Thank you.
elektr0
could somebody please help me with the EAGLE PCB tool.
1) Is there a possiblity to merge (boolean add) RECTS, SIGNALS, WIRES within the board tool
2) Eagle does not recognize, that signal parts are connected through other layers by vias ?
Thank you.
elektr0