Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Question On PrimeTime

Status
Not open for further replies.

parsatt

Junior Member level 2
Junior Member level 2
Joined
Jan 6, 2010
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,450
Hi,
Currently I am designing a fully digital circuit. However, for some reason, I have to do a montecarlo analysis on the circuit. The only way I know is to do a feed the layout from encounter to cadence and do the spice on the extracted netlist.
However, it is really slow as the spice is a powerful tool and is really heavy. I was wondering if there is any built-in mismatch analysis tool on the digital tools like prime time-.... or so I can run the monte carlo analysis?


Any help is really appreciated.

Parsatt
 

PrimeTime is only a report timing engine, you provide netlist, one timing library corner (over ...), one RC extraction (over...), and some constraint and then you report the timing/cap/trans....
You could that for various combinason of timing library/RC corner if you have this data.
In general, the timing library is the typical voltage and +/-10% for worst and best.
The RC extraction is commonly worst/best/typical.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top