Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Question about Calibre RC extraction

Status
Not open for further replies.

raj_sundar

Newbie level 1
Newbie level 1
Joined
Jul 27, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
During a Calibre-RC extraction to generate an fsdb file, is their a switch I need to set so that so that the names of devices and instances get their names from the source which in this I would like to be the schematic netlist? I know that in STAR-RC I would set XREF:YES to achieve the same. Is there an equivalent switch in Calibre-RC? Without this switch, there is no mapping between the devices in the schematic file and the DSPF file as a result of which my back-annotation stats are very poor (i get only about 25% back-annotation done reported in my simulator log file).

Thanks.

Raj.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top