Shakirel
Newbie level 5
design of push pull converter transformer
I need a little help on designing a transformer for my push-pull converter.
The input voltage is from 9 to 18v,output should be 350v,operating frequency 100KHz,output current 0.2A and the core should be a ferrite one.
The push-pull is a center tapped version.
What value should i use for the flux?
Any help is welcomed.
I need a little help on designing a transformer for my push-pull converter.
The input voltage is from 9 to 18v,output should be 350v,operating frequency 100KHz,output current 0.2A and the core should be a ferrite one.
The push-pull is a center tapped version.
What value should i use for the flux?
Any help is welcomed.