Protel question (where can i find LCD in PROTEL ?)

[hassenman]

where can i find LCDs in protel , i searched all librairies and i didn't find any .

 

[zxfeng]

P*otel question (where can i find LCD in P*otel ?)

it doesn't exist in protel library, you must make lcd library by yourself

 

[hr_rezaee]

P*otel question (where can i find LCD in P*otel ?)

Hi
use header instead of it.
be careful, you must measure distance correctly in PCB.

 

[centiago]

You may use berg strip for connection. To ensure correct placement use header. If your LCD is without backlight use 14 pin. Use 16 pin for backlight.

I would advice using header depending on your PCB placement.

 

[haytham]

Why you need LCD symbol
All what you need is its connector
You should search for a connector with the same pin count and that's it

 

[hassenman]

Re: P*otel question (where can i find LCD in P*otel ?)

Why you need LCD symbol
All what you need is its connector
You should search for a connector with the same pin count and that's it

I actually need the footprints of the LCD , but i didn't found in Protel .

 

[centiago]

Pls refer datasheet of LCD. The pin pitch is 100 mill (same of ICD/Burg Connector)
Rest the mechanical infomration can be given obtained from datasheet.

 

[nishal]

P*otel question (where can i find LCD in P*otel ?)

Use SIP16 which can be found in PCB Footprints.lib
it is the same pitch that of the LCD.
If your lcd pin differs from 16 pin, use the appropriate SIP component from the library

Hope this helps.