lerameur
Junior Member level 1
Hello,
The datasheet of the LTC6904 square wave generator says:
Slave AddressThe LTC6904 can respond to one of two 7-bit addresses. The first 6 bits (MSBs) have been factory programmed to 001011. The address pin, ADR (Pin 4) is programmed by the user and determines the LSB of the slave address, as shown in the table below:
ADR (Pin 4)LTC6904 Address#1: 0010111
address #2 : 0010110
SInce I have both IC on the same line, I'd liek to distinguish each of the IC. the datasheet does not tell me how to initially program each of the IC to those addresses. Anybody has a clue ?
Ken
The datasheet of the LTC6904 square wave generator says:
Slave AddressThe LTC6904 can respond to one of two 7-bit addresses. The first 6 bits (MSBs) have been factory programmed to 001011. The address pin, ADR (Pin 4) is programmed by the user and determines the LSB of the slave address, as shown in the table below:
ADR (Pin 4)LTC6904 Address#1: 0010111
address #2 : 0010110
SInce I have both IC on the same line, I'd liek to distinguish each of the IC. the datasheet does not tell me how to initially program each of the IC to those addresses. Anybody has a clue ?
Ken