Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Guys,
I have desolder working LCD 16x2 from other circuit, however,when I directly connect with correct connection, it does not working.
Should I really add resistor 100ohm to Vdd ?
the explaination is correct, i too had faced this problem, send the 0x30 command 3 times when you initialize the lcd in routine. adding 100 Ohm is optional.
Any idea how to sent the command in my mikroC ?
My LCD right now doesn't work at all even show whole black dot by directly connect to the power supply.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.