majorbra
Newbie level 6
co-simulating in GENESYS
I´m simulating an oscillator in genesys. Simulating just with harmonic balance and schematic OK, but when I run a co-simulation using Layout and EMPOWER, don´t work.
messsages:
Warning: Element OSC1 REAL.SG1 has 2 nodes in the schematics and 1 ports in the EM simulation. The extra nodes in the co-simulation will be grounded.
HB: Oscillator frequency not found run simulation(s) aborted
anybody can give me an Idea?
circuit is attached.
tks all.
I´m simulating an oscillator in genesys. Simulating just with harmonic balance and schematic OK, but when I run a co-simulation using Layout and EMPOWER, don´t work.
messsages:
Warning: Element OSC1 REAL.SG1 has 2 nodes in the schematics and 1 ports in the EM simulation. The extra nodes in the co-simulation will be grounded.
HB: Oscillator frequency not found run simulation(s) aborted
anybody can give me an Idea?
circuit is attached.
tks all.