ghaffer
Newbie level 6
site:www.edaboard.com pml hfss
Hello all
I am trying to do an oblique angle simulation in HFSS 10. When I assign Master/Slave boundaries to the waveguide and then assign PML to the both faces, it says that simulation could not be run due to the fact that Mater/Slave boundaries are touching with the PML boundaries and both of them dont have the same parameters!!!!!!!!
Can some one help me in resolving this problem?
What about the PML reference as Frequency Selective Surface?
Regards
Ghaffer
Hello all
I am trying to do an oblique angle simulation in HFSS 10. When I assign Master/Slave boundaries to the waveguide and then assign PML to the both faces, it says that simulation could not be run due to the fact that Mater/Slave boundaries are touching with the PML boundaries and both of them dont have the same parameters!!!!!!!!
Can some one help me in resolving this problem?
What about the PML reference as Frequency Selective Surface?
Regards
Ghaffer